top of page




Our field of activity

Electronic devices have become an integral part of our everyday life and are playing an increasingly important role in our lives. Of course, the distributor must ensure that the product quality is flawless in terms of electrical safety, but also electromagnetic compatibility.

We offer the necessary verification for this. This can be done for the national ÖVE mark, but also in accordance with international procedures such as ENEC, CCA and CB and for approvals according to ETS guidelines.


As part of the conformity assessment procedure, we are happy to check your product in accordance with the Low Voltage Directive (2014/35 / EU), the EMC Directive (2014/30 / EU),  the RED (2014/53 / EU) or the Motor Vehicle Directive (2007/47 / EC).


Our expertise also extends to advice and support for product developments or expert reports on e.g. electrosmog measurements, damage assessments and utility value tests, etc.

2014/35 / EU
Low voltage directive

2014/30 / EU
EMC directive

2014/53 / EU
Radio Equipment Directive

the department

Elektronische Leiterplatte

2014/35 / EU
Low voltage directive

This European directive is probably one of the most important in the electronics sector.


It was approved by the European Parliament and the Council on February 26, 2014


"Harmonization of the laws of the member states on the provision of electrical equipment for use within certain voltage limits on the market"


Example standards

The guideline applies to all electrical equipment with a nominal voltage between 50 and 1000V AC and between 75 and 1500V DC, for example in the range:

Luminaires, LED modules, ballasts,
Lamp holders, ...

IEC EN 60598, IEC EN 62031, IEC EN 61347, ...

Elektrokabel mit Skala

2014/30 / EU
Electromagnetic Compatibility Directive

This European guideline regulates protective measures and corresponding control measures for irradiation and radiation from electronic products of all kinds.


It was approved by the European Parliament and the Council on February 26, 2014


"Harmonization of the laws of the member states on electromagnetic compatibility"


Example standards

The guideline applies to all devices or fixed systems that can cause electromagnetic interference or whose operation can be impaired by this interference.

Lights, telecommunication equipment, ...

EN 55015, EN 55014, EN 55032, EN 55035, ...


2014/54 / EU
Radio Equipment Directive

This European directive is particularly important for IoT applications. All devices that transmit or receive radio waves must meet this European directive.


It was approved by the European Parliament and the Council on April 26, 2014


"Provision of radio equipment and the repeal of Directive 1999/5 / EC"


Komponenten nach innen von Handy

Example standards

The directive applies to all radio equipment. These are electronic products that emit and / or receive radio waves for the purpose of radio communication and / or radio location.

Telecommunication products

IEC EN 62368



Thomas Thun

Head of Department Electrical Engineering and Electronics

Phone: 01 33 126 434


Head of Department

Günter Gamperl

Deputy Head of Department

Electrical engineering and electronics

Electromagnetic compatibility area

Phone: 01 33 126 456

Philipp Petzl

Deputy Head of Department

Electrical engineering and electronics

Product safety area

Telephone: 01 33 126 431


Electrical product safety

In the area of electrical safety, we offer testing according to CE, CB, ENEC and ÖVE test marks ...

Electromagnetic compatibility

Be sure that your device does not emit any undesired radiation or that it cannot be influenced by any ...

IP classification

Do you want your device to be checked for tightness against dust, water or solids? No problem, we are at your side ...

Acceptance measurements of cabling routes

We are authorized to approve your cabling routes and to confirm this with an expert opinion ...

Lights, devices for lights and LED modules

Everything to do with light is our competence. Whether control unit or floor lamp, none of this is a problem for us ...

Installation switches and plugs

In fact, all devices have to be connected to the supply network. We are the right contact for you to check for conformity ...

Smart home devices

Are you developing a smart home device? Regardless of whether wired or wireless, we are your right contact ...

Partial exams

Material tests of e.g. housings are our competence, e.g. ball pressure, glow wire or tracking resistance tests, ...

Submit your request today

State Research Institute - TGM

Tel: 01 33 126 434

Write to us today! We will contact you immediately to clarify any details and to advise and support you as best as possible.

We are at your disposal for your individual concerns! 

Erfahren Sie mehr über uns...
Thomas Thun

Erfahren Sie mehr über uns...

bottom of page